Connecting An Antenna Or Cable Tv; Basic Tv Connections - JVC HR-XVC16BUC Instructions Manual

Connecting an Antenna
Connecting an Antenna
or Cab le TV
or Cab le TV
a Antenna a
:
Disconnect the antenna from the rear of the TV and
identify the antenna cable. If it is a round 75 ohm
coaxial cable connect it directly to the jack marked
ANT.IN on your DVD+VCR. If your antenna cable is
flat connect it to a 300-ohm to 75-ohm antenna
adaptor (not supplied) and slip the adaptor over the
ANT.IN jack. Don't attempt to screw it into to the
DVD+VCR.
b Cable TV: b
If your cable connection has no converter or
descrambler, unscrew the cable from your TV and
attach it to the ANT.IN jack on the DVD+VCR.
If a converter is required connect a coaxial cable from
the wall jack to the IN connector on the converter,
and a coaxial cable from the OUT connector on the
converter to the ANT IN on your DVD+VCR. This
cable hookup permits both TV and DVD+VCR
operation.
Antenna
OR
Rear of DVD+VCR
Antenna
OR
To view or record a CATV channel when
using cable box
1 Tune the TV to the DVD+VCR output channel
(CH 3 or 4).
2 Set the DVD+VCR channel selector to the cable
output channel. (Example: CH3)
3 Select a channel using the cable converter.
Notes:
With this connection, you cannot record one program
•
while viewing another.
If you are using a cable box to tune channels, it is not
•
necessary to do Auto Channel Set.
Basic TV Connections
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your TV.
Rear of TV
ANTENNA
VIDEO
AUDIO INPUT
INPUT INPUT
L
R V A1
Rear of TV
R
Rear of DVD+VCR
C
A2
Pr Pb Y
R L
COMPONENT/PROGRESSIVE SCAN
AUDIO INPUT
VIDEO INPUT
11