Edit To Or From Another Video Recorder - JVC HR-XVS20EK Instructions Manual

Edit To Or From
Another Video
Recorder
A
TV receiver Player
21-pin SCART cable
AV mode
Recorder
B
Recorder
21-pin SCART cable
(not provided)
Another recorder
Player
Advantages of S-VHS video recorders
You can edit from VHS to S-VHS, S-VHS to VHS, or, from
S-VHS to S-VHS.
From VHS to S-VHS: Record VHS playback signals in the
S-VHS mode. Although the picture quality is inherently
limited by that of the original, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
From S-VHS to VHS: Because the picture quality of the
source material is very high, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
From S-VHS to S-VHS: All signals will be transferred with
minimum degradation.
Your unit
(not provided)
Another recorder
Your unit TV receiver
AV mode
You can use your unit as the source player or as the
recording deck.
Slide the TV/S-VHS/DVD switch to the right.
A
Make connections.
Connect the player's 21-pin SCART connector to the
unit's 21-pin SCART connector as illustrated.
A When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording
deck.
B When using your unit as the recording deck:
— connect its L-1 IN/OUT or L-2 IN/DECODER
connector to the source player.
If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set "L-1
OUTPUT" to "S-VIDEO". (
— when using your unit as the recording deck, set "L-2
INPUT" to "S-VIDEO". (
B
Select the S-VHS deck.
On the unit
Press S-VHS/DVD repeatedly so that the S-VHS indicator
lights up.
On the remote control
Press S-VHS so that the S-VHS indicator lights up.
C
Set the input mode of recording deck.
With this unit, press AUX (number key "0") and/or PR to
select "L-1" for the L-1 IN/OUT connector, or "L-2" for
the L-2 IN/DECODER connector, depending on the
connector being used.
When using another recorder as the recording deck, refer to its
instruction manual.
When using the L-2 IN/DECODER connector, set "L-2
SELECT" to "A/V". ( pg. 63)
D
Set the edit mode.
See "PICTURE CONTROL" on page 71.
E
Start the source player.
Engage the Play mode of the source player.
F
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
All necessary cables can be obtained from your dealer.
For Y/C signal input/output, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.
When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
When you use this unit as the source player for editing, be sure
to set "O.S.D." to "OFF" before starting. (
If you are using another recorder with S-Video and Audio
output connectors, connect its S-Video and Audio output
connectors to this unit's front panel S-VIDEO and AUDIO
input connectors. Then, set the unit's input mode to "S-1" in
step C.
61
pg. 62)
pg. 63)
pg. 72)