Connections; Basic Connections - JVC HR-XVC29SUM Instructions Manual

Jvc dvd player & video cassette recorder instructions
Hide thumbs Also See for HR-XVC29SUM:
Table of Contents

Advertisement

Connections

Basic Connections

Antenna or Cable
Coaxial cable
Flat feeder
AC Outlet
AC Power Cord
Back of unit
Audio/video cable
(not supplied)
To Audio/video
input connectors
Matching transformer
(not supplied)
AUDIO
OUTPUT
VIDEO OUTPUT
VHF/UHF
IN
VHF/UHF OUT
RF cable
(supplied)
To 75 ohm
Terminal
TV
~
Place the unit on a stable, horizontal surface.
Ÿ
Connect the unit to TV.
RF Connection
1 Disconnect the TV antenna from the TV.
2 Connect the TV antenna cable to the VHF/UHF
IN connector on the rear panel of the unit.
3 Connect the supplied RF cable between the
VHF/UHF OUT connector on the rear panel of
the unit and the TV's antenna terminal.
AV Connection
1 Connect the antenna, unit and TV as per "RF
Connection."
2 Connect an optional audio/video cable between
the AUDIO/VIDEO OUTPUT connectors on the
rear panel of the unit and the TV's audio/video
input connectors.
• Set your TV to AV mode.
!
Plug the end of the AC power cord into an AC
outlet.
Set the VCR channel.
The VCR channel is the channel on which you can
watch the picture from the unit on the TV only when
using RF connection. With RF connection, set the
VCR channel to "3 CH" or "4 CH."
• The VCR channel is preset to "3 CH." Set to "4 CH" if
the Channel 3 is used for broadcasting in your area.
• With AV connection, set the VCR channel to "– CH"
(off).
To set the VCR channel, perform the following steps:
Before performing the following steps:
• Make sure there is no cassette inserted in the unit.
• Make sure the unit is turned on, then press
VCR/DVD on the unit so that the VHS indicator
lights up on the front display panel.
1 Press POWER on the unit to turn off the unit,
then press 7 STOP on the unit for more than 5
seconds. "3 CH" appears on the front display
panel.
2 Press CH +/– on the unit to select "3 CH," "4 CH,"
or "– CH" (off), then press POWER on the unit.
• If Plug&Play or Tuner setting has not previously
been performed, the Language Select screen
appears and Plug&Play takes place automatically.
9 9

Advertisement

Table of Contents
loading

Table of Contents