SanDisk CompactFlash Product Manual page 81

Data 7 6
Attribute
Offset
0EEh 41h W R
0 1
0F0h 99h M
1
0F2h 27h R DI
0 0
0F4h 55h X
0
0F6h 4Dh X
0
0F8h 5Dh X
0
0FAh 75h X
0
0FCh EAh R S
1 1
®
CompactFlash Memory Card Product Manual, Rev. 10.0 © 2002 SANDISK CORPORATION
5 4 3 2 1 0
P B Interface Type
0 0 1
MS IR IO T P
0 1 1 0 1
PI AI SI HV LV NV
1 0 0 1 1 1
Mantissa Exponent
Ah = 5.0 5h = 1V
Mantissa Exponent
9h = 4.5 5h = 1V
Mantissa Exponent
Bh = 5.5 5h = 1V
Mantissa Exponent
Eh = 8.0 5h = 10
E IO AddeLines
1 Ah = 10
Description of Contents
I/O Interface(1), Bvd's and wProt not
used; Ready/-Busy active but Wait
not used for memory cycles.
B:Battery Volt Detects Used
P:Write Protect Used
R:Ready/-Busy Used
W:Wait Used for Memory Cycles
Vcc Only Power Description; No
Timing; I/O and IRQ present; No
Mem Space; Misc Entry present
P:Power info type
T:Timing info present
IO:I/O port info present
IR:Interrupt info present
MS:Mem space info type
M:Misc info byte(s) present
Nominal Voltage Follows
NV:Nominal Voltage
LV:Mimimum Voltage
HB:Maximum Voltage
SI:Static Current
AI:Average Current
PI:Peak Current
DI:Power Down Current
Vcc Nominal is 5Volts
Vcc Nominal is 4.5Volts
Vcc Nominal is 5.5Volts
Max Average Current over 10 msec is
80 mA
Supports both 8 and 16 bit I/O hosts.
10 Address lines with range so card
will respond only to indicated (1F0-
1F7, 3F6-3F7) on A9 through A0 for
I/O cycles. IO AddrLines:#lines
decoded
E:Eight bit only hosts supported
S:Sixteen bit hosts supported
R:Range Follows
CIS Description
CIS Function
TPCE_IF
TPCE_FS
Power Parameters for Vcc
Vcc Nominal Value
Vcc Minimum Value
Vcc Maximum Value
Max Average Current
TPCE_IO
6-9