Oil Pressure Switch; Brake Light Switch; Neutral Switch - Honda VF1000F 1985 Shop Manual

SWITCHES
OIL PRESSURE SWITCH
Disconnect the oil pressure switch lead and remove the switch.
Check for continuity while applying pressure to the switch.
No continuity: Above 10-20 kPa
(0.1-0.2 kg/em' , 1.4-2.8 psi)
Replace the switch if necessary.
Apply
a liquid
sealant to t he switch threads before installing
the switch.
Screw the switch into the crankcase but stop two threads from
the bottom. Then tighten it t o the specified torque.
TORQUE : 10-14N ·m (1 .0-1.4 kg·m, 7- 10 ft·lb)
NOTE
To prevent crankcase damage, do not overtighten the
switch .
BRAKE LIGHT SWITCH
REAR
Check the rear brake light switch for continuity with the rear
brake applied.
FRONT
Check the front brake light switch for continuity with the
fro nt brake applied.
Repl ace the switches if necessa ry.
NEUTRAL SWITCH
INSPECTION
Remove the left side cover. Disconnect the neutral switch
connector.
Check the switch for conti nuity between the switch connector
termina l and ground.
There sho uld continuity with the transmission in neutral and
no conti nui ty with the transmission in any g~ar.
21-2