Brake And Taillight Sensor; Headlight - Honda VF1000F 1985 Shop Manual

SWITCHES
BRAKE AND TAILLIGHT SENSOR
Remove the seat and rear compartment under cover.
Turn the ignition switch on.
Check the source voltage at the black/brown lead.
If there is no voltage, check and repair the source circuit.
If there is voltage, measure the voltage at the white/yellow
(positive) and green/veil ow (negative) wires.
VOLTAGE: 5V
If there is no voltage, replace the sensor unit.
HEADLIGHT
SINGLE HEADLIGHT MODEL
Remove the fairing (page 14-1).
Remove the three screws and headlight from the headlight
base.
Disconnect the headlight coupler and rubber cap from the
headlight.
Turn the bulb retainer counterclockwise and remove the
retainer, spring and bulb.
Replace the bulb with a new one and install in the reverse
order of removal.
NOTE
Install the rubber cap with its TOP mark facing up,
21-9
BRAKE AND TAILLIGHT SENSOR
-.....~ r
. -
' 70
....