Input/Output Setting - JVC DR-MH300BE Instructions Manual

Input/Output Setting

9
The SCART connector supports the
connection of composite video signals.
Settings must correspond with the type of
video signal to use and the device to
connect.
IMPORTANT:
.. . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . .
0
For normal use, you can leave the default settings as
they are.
0
See the following page regarding each setting. Setup
Menu AF-1 INPUTB, AL-1 OUTPUTB, AL-1 INPUTB,
AL-2 SELECTB [
0
For image output format other than A576iB (during up
convert or progressive scan), viewing is not possible
as the images are distorted.
Possible combinations
AL-2 SELECTB (*1)
AVIDEO/RGBB
AS-VIDEO/RGBB
ASAT VIDEO/RGBB
ASAT S-VIDEO/RGBB
ADECODERB (*5)
AL-1 INPUTB
AVIDEOB
AS-VIDEOB
*1 Switching to RGB signals is automatic.
*2 Component videos will be output from the [COMPONENT] terminal. Be sure to set to ACOMPONENTB if viewing via component
video.
*3 With this setting, signals from the [L-2 IN/DECODER] terminal will be output to the [L-1 IN/OUT] terminal even if this unit is
turned off, except during EPG data downloading.
*4 This setting cannot be made if AL-2 SELECTB is set to ASAT VIDEO/RGBB or ADECODERB.
*5 Will not be displayed if AČESKÁ REPUBLIKAB, AMAGYARORSZÁGB, APOLSKAB or AOTHER EASTERNB
setting.
H EN
34
B
A,
P102, 103] i - l
ASCART VIDEOB
(*4)
A
Access the setup menu.
B
Select "FUNCTION SET UP".
C
Select "VIDEO IN/OUT".
SELECT
D
-
D
Set the input/output terminal.
A
Select and confirm on AF-1 INPUTB.
SELECT
E
B
Select and confirm on AL-1 OUTPUTB.
C
Select and confirm on AL-1 INPUTB.
D
Select and confirm on AL-2 SELECTB.
0
See the description below for the combinations
of settings.
E
Exit setup.
AL-1 OUTPUTB
ASCART S-VIDEOB
F-1 INPUT
CONFIRM
ASCART RGBB ACOMPONENTB (*2)
is selected for area
FUNCTION SET UP
VIDEO IN/OUT
VIDEO
S-VIDEO
(*3)
(*3)
(*3)
(*4)