Table of Contents
Advertisement
Filename [DR-MH30UJ_04Name.fm]
DR-MH30UJ_00.book Page 24 Monday, July 12, 2004 3:17 PM
INITIAL SETTINGS
24
EN
Cable Box and/or DBS Receiver Control
Setting
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box and/or DBS receiver's channels during timer recording.
NOTES:
The Controller is effective for "VCR Plus+
(
pg. 46), or "Manual Timer Programing" (
When connecting your cable box, refer to its instruction manual.
Installing Controller
1
If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2
Fix securely using the adhesive strip attached on the back of the
Controller.
Your unit
3
Connect the controller to the unit.
a
Cable box or DBS receiver
Transmitter
Controller
To ANTENNA IN
Page 24
®
Timer Programing"
pg. 48).
Cable box or DBS receiver
Controller
(suggested locations)
To RF output
To Audio/video
output
or
To AUDIO/
VIDEO INPUT
Your unit
CABLE
BOX
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver
to the ANTENNA IN connector on the rear of your unit.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear
of the unit.
If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit's AUDIO/VIDEO
INPUT connectors and the cable box to your unit's ANTENNA IN
connector.
4
Connect the Controller to the CABLE BOX connector on the rear
panel.
Setting Brand And Channel
After installation, set the cable box and/or DBS receiver's brand
and channels correctly; otherwise, the Controller cannot work
correctly.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/DBS/DVD switch to DVD.
ENTER
1
Turn on the cable box and/or DBS receiver.
2
Press SET UP to access the Main Menu screen.
3
Press w e to select "INITIAL SET UP", then press t.
4
Press w e to select "STB SET UP", then press t.
5
Press rt to select "CABLE
BOX SET" or "DBS RECEIVER
SET", then press ENTER.
6
Press rt to select "CABLE
BOX OUTPUT CH" or "DBS
RECEIVER OUTPUT CH", then
press ENTER.
Masterpage:Left+
CABLE/DBS
TV
DVD
rtwe
SET UP
DVD VIDEO SET UP
HDD/DVD SET UP
FUNCTION SET UP
INITIAL SET UP
TUNER SET UP
STB SET UP
CLOCK SET UP
CABLE BOX SET
DBS REC VER SET
SET UP
ENTER
SELECT WITH [
] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
INITIAL SET UP > CABLE BOX SET
CABLE BOX OUTPUT CH
OFF
CABLE BOX BRAND
1
TEST MODE
SET UP
ENTER
SELECT WITH [
] THEN PRESS [ENTER]
PRESS [SET UP] TO EXIT
EXIT
SELECT
Monday, 12 July 2004 14:10
Advertisement
Table of Contents
