JVC DR-MH300BE Instructions Manual page 111

Timer Programming
HDD CAN NOT SET TIMER PROGRAMME DUE
TO SHORTAGE OF CAPACITY
DELETE UNWANTED TITLE OR CHANGE
RECORD MODE
CAN NOT PERFORM TIMER RECORDING
CHECK PROGRAMME LIST TO CONFIRM
HDD/DVD SET CLOCK BEFORE TIMER
PROGRAMMING
Dubbing
HDD/DVD CAN NOT DUB DURING RECORDING
STOP RECORDING THEN RETRY
THE i.LINK DEVICE THAT YOU HAVE
CONNECTED IS NOT RECOGNIZED
MAKE SURE THAT DEVICE IS CONNECTED
PROPERLY AND POWERED ON
Disc
DVD COULD NOT CANCEL DISC FINALISATION
CHECK THE DISC
COULD NOT FINALISE THE DISC
CHECK THE DISC
COULD NOT FORMAT THE DISC
CHECK THE DISC
Message
Message
Message
Advice
There is no recordable space remaining in the hard disk.
Increase the recordable space by dubbing the currently
recorded programmes to DVD first, then delete the
programmes. [ P80]
For HDD timer programming, there are timer programmes
that cannot be recorded within the duration set due to the
remaining capacity of HDD. Verify, cancel or change the
timer programme from the programme list where necessary.
[ P57]
Set the clock. [ P35]
Advice
Dub after recording ends.
Check that the DV device is correctly connected to the DV
input terminal on the unit's front panel.
Advice
The disc may be dirty. Clean the disc and try again.
EN I 111