Removing The Driven Pulley Shaft Bearing - VESPA GT 125 Workshop Manual

Vespa GT 125-200
With the appropriate tools, remove the oil seal as
shown in the figure.
Specific tooling
020359Y 42x47-mm adaptor

Removing the driven pulley shaft bearing

When removing the driven pulley shaft, the corre-
sponding bearing and oil seal, remove the trans-
mission cover and the clutch group as explained
above.
- Extract the driven pulley shaft from its bearing.
- Remove the oil guard using a screwdriver, work-
ing from inside the bearing and being careful not
to damage the housing, make it come out of the
belt transmission side.
- Remove the seeger ring shown in the figure
With the sectional punch, remove the driven pulley
shaft bearing.
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020363Y 20 mm guide
Engine
ENG - 119