JVC DR-M150SEK Instructions Manual page 9

Filename [M150SEK_04DiscInfo.fm]
M150SEK_00.book Page 9 Wednesday, June 15, 2005 4:04 PM
DVD VIDEO Marks
Sometimes marks are printed on a DVD disc and/or on its
packaging to indicate information regarding the contents and
functions of the disc. Check the marks indicating the contents and
functions of the disc. Note, however, that in some cases a disc may
not include a mark even for a function it supports.
Marks related to video
Number of subtitles
Recorded under the
standard 4:3 aspect
ratio
Video playback is in Wide video mode (16:9)
on wide televisions, but in letter box on
televisions with standard 4:3 aspect ratio.
Video playback is in Wide video mode (16:9)
on wide televisions, but pan and scan is used
on televisions with standard 4:3 aspect ratio
(either the left or right side of the image is cut-
out).
Marks related to audio
Number of audio tracks
Dolby Digital mark
It has been developed by Dolby Laboratories as
a digital surround system.
DTS (Digital Theater Systems)
You can enjoy DTS audio if you connect an
amplifier with a built-in DTS decoder to the
DIGITAL OUT connector of the unit.
Placing A Disc
Opening the disc tray
Press M to open the disc tray.
Number of angles
Screen includes
black bands at the
top and the bottom
●
Pressing the button again closes the disc tray.
of image which has
●
Use the button to open and close the disc tray.
a standard 4:3
●
Do not block the disc tray with your hand while it is opening or
aspect ratio (letter
closing as this may result in hardware failure.
box)
●
Do not place unplayable discs or any object other than a disc on
the disc tray.
●
Do not press down strongly on the disc tray or place any heavy
objects on it.
Discs without cartridges
Place the disc on the disc tray with the label side facing up. Since
disc size changes depending on the disc to be played back, be
sure to correctly align the disc with the grooves for its size. If the
disc is not in its groove, it may be scratched or otherwise damaged.
To insert an 8 cm disc, place it according to the inner groove.
DVD-RAM discs contained in cartridges
Double-sided discs:
Remove the disc from the cartridge. Align the disc with the grooves
on the disc tray as shown in the illustration and insert with the side
you wish to play back or record facing down. If you insert the disc
with ASide AB facing down, programmes are recorded on side A.
Single-sided discs:
Remove the disc from the cartridge. Align the disc with the grooves
on the disc tray as shown in the illustration and insert with the label
side facing up.
Masterpage:Right+
DISC INFORMATION
PR
DV DV IN
F-1
S-VIDEO VIDEO L(MONO) AUDIO R
Label side facing up
9
EN
Disc tray