Reiner jetStamp 792 Operating Instructions Manual page 14

Numbering device - setting starting point or figures :
Press [ NEXT ] if necessary repeatedly, until the display shows
"INPUT - NUMBERER 1"
INPUT - NUMBERER 2
*
Only available with a customer-specific impression (P:26 ... P:29),
which has been prepared using PC-Set
Press [ VARY ] to select the first position of the entry
Set this digit by using [ INC ] to increase, or [ DEC ] to decrease it
With the [ LEFT ] and [ RIGHT ] buttons, you can move to the
other positions. They can be set using [ INC ] and [ DEC ]
To exit the setting press [ RETURN ]
Press [ RETURN ] again to exit the menu. The selected
impression is displayed again, and jetStamp is ready for use
Numbering device - additional functions
Increasing and / or decreasing numbering between limits.
Press [ MODE ] if necessary repeatedly, until the following functions
appear in the menu bar:
[ N1 MAX ]
[ N1 MAX ]
[ N1 MIN ]
[ N1 MIN ]
[ N1 CLR ]
[ COUNT ]
[ CLEAR ]
For further notes on additional numbering-device functions, see page 22
14
*
= upper limit is activated (pressing this button again
displays the upper limit)
= upper limit is de-activated
= lower limit is activated (pressing this button again
= lower limit is de-activated
= all limits de-activated
= increases or decreases the counter reading by one step
= sets the counter back to the limit
"INPUT - NUMBER 1"
INPUT - NUMBER 2
displays the lower limit)
or
*