Setting Time And Date - Reiner jetStamp 792 Operating Instructions Manual

To set the time and date, an impression must first be selected that contains
the date, or date and time as appropriate.
First select an impression that contains the date, or date and time
as appropriate (see also pages 8 and 9).
Press [ MODE ] if necessary repeatedly, until the menu item
"CLOCK" is displayed
Press [ CLOCK ] to select the required menu item
The display shows "INPUT - TIME 1"
you will see the time currently set
i
This menu may be protected by a password.
In that case the correct password must first be entered.
Note
Press [ VARY ] to select the minutes figures and set the
minutes by pressing [ INC ]
Press [ NEXT ] to select the hours figures and set the
hours by pressing [ INC ]
Press [ RETURN ]
to the date display (display shows "INPUT - DATE 1"
Press [ VARY ] to select the year figures and set the year
by pressing [ INC ]
Press [ NEXT ] to change to the month display and use
[ INC ] to set the month
Press [ NEXT ] to change to the days figures and use
[ INC ] to change the setting
Press [ RETURN ] if necessary twice, to exit the menu.
The impression selected will be displayed, and the stamp is ready for use
*
When using a customer-specific impression (P:26 ... P:29) ,
you can change to
at this point by pressing [ NEXT ] (see page 10)
12

Setting time and date

and then [ NEXT ] to change
"INPUT - TIME 2
*
and below it
or "INPUT - DATE 2"
*
)