Advertisement
Zero Clearance Stove
Accumulation of dust on exhaust fan blade. Remove screws on motor mounting
bracket, remove motor, and thoroughly clean fan blade. Windy conditions outside
of home blowing against exhaust air. Safety switch defective. Replace control.
Do not allow ashes to overflow out of ash pan, this can cause blockage in exhaust
system. Causing safety switch to trip out on reset, resulting in loss of fire.
Blockage will have to be cleared before pushing reset button and restarting fire.
The Keystoker ZC stove is approved for mobile homes. The oxygen supply for
combustion is not taken from the home. No preheated air from home is wasted on
combustion and forced out exhaust system. The combustion air is taken from
outside, drawn in, preheated, then forced into fire chamber and returned outside
through exhaust system.
To meet U.L. REQUIREMENTS FOR MOBILE HOMES COMBUSTION
AIR MUST be taken from outside of home. To direct vent through a combustible
wall, it is necessary to use proper wall thimbles to obtain '0' degree clearance.
MAINTENANCE FOR EXHAUST SYSTEM:
Motor: Inspect and oil motor once during heating season and also at the end of
heating season. Motor should rotate freely.
Wheel: Inspect the venter wheel once during heating season, and also at the end of
heating season. Thoroughly clean any soot, ash or coating which inhibits either
rotation or air flow.
Vent System: Inspect all vent connections annually for looseness, evidence of
corrosion and for flue gas leakage. Replace, seal or tighten pipe if necessary.
4
Advertisement
