Advertisement
IF FIRE STAYS LIT, BUT STOVE IS TOO HOT
If convection blower cycles on and off often and produces too much heat, whether
the fire bed is too long or timer is running too long. If you reduce coal feed or
remove timer pins, do not make radical changes. Reduce coal feed 1 or 2 turns OR
remove 1 pin from timer. Then wait several hours before making any more
reductions. A sudden radical change may be too much and cause fire to go out.
TO ORDER PARTS
Find the metal 1 ½" x 3" Keystoker label fastened to stoker unit body, near gear
motor. The four or five digit number will be required to get proper replacement
parts from your dealer.
THE BURNING OF ALL FOSSIL FUELS GENERATES CARBON
MONOXIDE GASES. CARBON MONOXIDE GASES ARE TOXIC, CAN
CAUSE SICKNESS OR BE FATAL.
To prevent toxic carbon monoxide gases from entering the home, certain
precautions must be taken.
Ash tub must be emptied on a regular basis to prevent ashes from
overflowing into ash pit area. Excessive ash accumulation may impede air flow to
chimney, preventing gases to be drawn up chimney.
Fire door and ash door must be kept closed at all times during normal
operation.
It is necessary to keep coal in hopper while stove is in operation.
In most applications it is sufficient to clean stove and stove pipe twice
during heating season. However, under extreme weather conditions, or high
demand on stove running periods, the stove and stove pipe may need more
frequent cleaning. Clean as often as necessary.
CAUTION: ASH PAN IS HOT-Always Use Gloves to Remove Ash Pan
Before removing ash pan, turn switch off, or pull power cord plug from
110V outlet. Open ash door. Use a good pair of gloves, to remove ash pan. Place
filled ash pan on a non-combustible surface. Slide an empty ash pan into stove.
Close ash door. Turn switch on or plug power cord back into 110V outlet.
Zero Clearance Stove
SAFETY
17
Advertisement
