About Audio Output (Audio Out) (Pdp-504Cmx/Pdp-434Cmx Only) - Pioneer PDP-505CMX Operating Instructions Manual

4
Press the SET button to select [INPUT1].
The factory default setting is [OFF]. Each time the
SET button is pressed, the selector function switches
alternately as shown:
3 OFF
INPUT1 2
÷ OFF .......... [AUTO FUNCTION] is disabled.
÷ INPUT1 ..... ÷ When a signal is detected at INPUT1,
the input source automatically
switches to [INPUT1].
÷ After the [AUTO FUNCTION] mode
has caused the input to switch, if the
input signal is no longer detected then
the input source reverts to the one
selected before instigating the
[AUTO FUNCTION] mode command.
÷ If the input changes when the unit is
in [AUTO FUNCTION] mode, pressing
the INPUT button to select a different
input causes the [AUTO FUNCTION]
mode to be temporarily disabled. To
enable again, cycle the power ON/OFF.
.
5
When finished with the setting, press the MENU
button to return to the normal screen image.
Reminders
÷ The [AUTO FUNCTION] for [INPUT1] is supported only when a
separate SYNC or composite SYNC analog RGB signal is input.
(When a G ON SYNC or component video signal is input,
[AUTO FUNCTION] is disabled.)
÷ The [AUTO FUNCTION] setting affects all input sources.
About audio output (AUDIO OUT)
(PDP-504CMX/PDP-434CMX only)
The signal level produced at the AUDIO (OUTPUT) jack
can be set to [FIXED] or [VARIABLE] (linked to the
VOLUME) as desired.
MENU
5/∞
2/3
SET
Main operating
panel
MENU
2/3
SET
5/∞
Remote control
1
Press the MENU button to display the menu screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
ENTER
SET
2 Use the 2/3 buttons to select [OPTION].
MENU
PICTURE SCREEN
LANGUAGE
ENERGY SAVE
SCREEN MGT.
ORBITER
MASK CONTROL
AUTO SET UP MODE
AUTO FUNCTION
AUDIO OUT
ENTER
S E T
3
Use the 5/∞ buttons to select [AUDIO OUT].
MENU
PICTURE SCREEN
LANGUAGE
ENERGY SAVE
SCREEN MGT.
ORBITER
MASK CONTROL
AUTO SET UP MODE
AUTO FUNCTION
AUDIO OUT
CHANGE
S E T
4
Press the SET button to select the desired audio
level setting.
The factory default setting is [FIXED].
Pressing the SET button causeis the setting to toggle
between the following options:
3 FIXED
VARIABLE 2
÷ FIXED ............ Audio output volume is fixed and
independent from the VOLUME
controls.
÷ VARIABLE ..... Audio output volume changes in
response to operation of the
VOLUME controls.
5
When finished with the setting, press the MENU
button to return to the normal screen image.
Reminders
÷ The [AUDIO OUT] setting affects all input sources.
÷ On the PDP-505CMX, only [VARIABLE] is supported.
Other Operations
INPUT1
SETUP OPTION
0
0
0
0
0
0
0
EXIT
MENU
INPUT1
SETUP OPTION
:
ENGLISH
:
STANDARD
:
OFF
:
OFF
:
ON
:
INACTIVE
:
OFF
:
FIXED
EXIT
M N U
E
INPUT1
SETUP OPTION
: ENGLISH
:
STANDARD
:
OFF
:
OFF
:
ON
:
INACTIVE
:
OFF
:
FIXED
EXIT
M N U
E
33
En