Pioneer PDP-505CMX Operating Instructions Manual page 33

PICTURE/SCREEN Adjustment
3 Use the 5/∞ buttons to select the adjustment
item then press the SET button.
MENU
PICTURE SCREEN
POSITION
CLOCK
PHASE
SCREEN RESET
ENTER
S E T
4 Use the 2/3 and 5/∞ buttons to select the
desired value.
÷ With [POSITION] selected, the 2/3
buttons control movement Horizontally
(H), and the 5/∞ buttons control
movement Vertically (V).
POSITION
H
0
SET SET
÷ Use the 2/3 buttons for the adjustments of
[CLOCK] and [PHASE].
CLOCK
SET
S E T
Note
If INPUT2 is selected, only the [POSITION] can be adjusted.
5
Press the SET button.
Pressing the SET button writes the value into the
memory and returns the display to the step 3 screen.
6
When adjustment is finished, press the MENU
button to exit the menu screen.
28
En
INPUT1
SETUP OPTION
:
0 / 0
:
0
:
0
M N U EXIT
E
V
0
MENU EXIT
:
0
EXIT
M N U
E
[SCREEN] mode adjustment items
Below are brief descriptions of the options that can be set
in the [SCREEN] mode.
POSITION
H ··························· Adjust the picture's position to the
left or right.
V ···························· Adjust the picture's position up or
down.
CLOCK ···················· Adjust letter breakup or noise on the
screen. This setting adjusts the unit's
internal clock signal frequency that
corresponds to the input video
signal.
PHASE ····················· Adjust so that there is minimum
flicker of screen letters or color
misalignment. This setting adjusts
the phase of the internal clock signal
adjusted by the [CLOCK] setting.
Reminders
÷ The [CLOCK] and [PHASE] adjustment items are supported
only for INPUT1.
÷ When the [CLOCK] frequency is changed, the [POSITION]
command's horizontal [H] option may require readjustment.
÷ If the adjustment items in the [SCREEN] mode are altered
excessively, the picture may not display properly.
÷ When [AUTO SET UP MODE] is set to [ACTIVE], selecting the
[POSITION] and [CLOCK] adjust modes cause a message
to display on the screen but adjustment is still possible.
However, if the input source is changed, the adjustment value
stored in memory is the one automatically set with the auto
setup mode. If you wish to record a manually set adjustment
value, set the [AUTO SET UP MODE] to [INACTIVE] (page 26)
before beginning your adjustments.
To reset [SCREEN] mode settings to the default
If settings have been adjusted excessively or the picture
no longer appears natural, it may prove more beneficial to
reset the [SCREEN] mode to the default settings instead
of continuing to make adjustments.
.
1 In step 3 from the previous procedure, use the 5/∞
buttons to select [SCREEN RESET] then press the
SET button.
SCREEN RESET
YES
SET
SET
2 Use the 2/3 buttons to select [YES]
the SET button.
All [SCREEN] mode settings are returned to the
factory default.
NO
EXIT
MENU
then
press