Pioneer PDP-505CMX Operating Instructions Manual page 36

Under factory default settings, the screen display
contents change as follows:
Inverse White mask
Set
image* display
[ONCE]
[TIME TO
10 minutes 30 minutes
ACTIVATE]
(set in step 7)
Inverse White mask
Set
image* display
[REPEAT]
[TIME TO
10 minutes 30 minutes
ACTIVATE]
24 hours
(set in step 7)
This cycle repeats
* The color and brightness of the current image are displayed in
inverse values. The respective RGB color output levels are
inverted with light areas appearing dark and dark areas
appearing light.
Reminders
÷ If set to [ONCE], after the screen management program ends,
this part of the display changes to the [OFF] message. To
continue the screen management program, scroll using the
2/3 buttons to select [ONCE] again or change to the option,
[REPEAT].
÷ During screen management operation while set to [ONCE] or
[REPEAT], if the display's MAIN POWER switch is turned OFF,
the screen management program ends. This part of the display
changes to show the [OFF] message. To continue with screen
management program, use the 2/3 buttons to select [ONCE]
or [REPEAT] again.
6 Use the 5/∞ buttons to select [TIME TO
ACTIVATE].
SCREEN MGT.
STATUS
TIME TO ACTIVATE
START
SET RETURN
7 Use the 2/3 buttons to set the time for the
screen management program to begin.
When the 2/3 buttons are pressed, the screen
management operation can be set from 0 to 24 hours
in 10-minute intervals.
8 Use the 5/∞ buttons to select [START].
SCREEN MGT.
STATUS
TIME TO ACTIVATE
START
SET
SET
Note
The [SCREEN MGT.] setting affects all input sources.
Power standby mode
Screen management
function ends here
Power Inverse
standby image*
mode
10 minutes
:
REPEAT
:
01H00M
MENU EXIT
:
REPEAT
:
00H10M
EXIT
MENU
9
Press the SET button.
The set value will be stored in memory, and the
screen will return to that shown in step 2.
The timer begins when the SET button is pressed,
and after passage of the time set in step 7, the screen
management program will begin operating.
10
When finished with the setting, press the MENU
button to return to the normal screen image.
Energy saving settings
(ENERGY SAVE)
The power control function allows screen brightness to
be suppressed as a means of lowering power
consumption and reducing display deterioration.
MENU
5/∞
2/3
SET
Main operating
panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
2 Use the 2/3 buttons to select [OPTION].
MENU
PICTURE SCREEN
LANGUAGE
ENERGY SAVE
SCREEN MGT.
ORBITER
MASK CONTROL
AUTO SET UP MODE
AUTO FUNCTION
AUDIO OUT
Other Operations
MENU
2/3
SET
5/∞
Remote control
INPUT1
SETUP OPTION
0
0
0
0
0
0
0
INPUT1
SETUP OPTION
:
ENGLISH
:
STANDARD
: OFF
:
OFF
: ON
:
INACTIVE
:
OFF
: FIXED
31
En