Replacing Armrest Pads; Disengaging The Seat To Rotate It Or Remove It; Adjusting The Seat Height - Invacare Colibri User Manual

Invacare® Colibri™

4.3 Replacing armrest pads

Remove the two mounting screws A that secure the armrest
1.
pad B to the arm C.
2. Remove the old armrest pad.
3. Install the new armrest pad and securely tighten with the existing
mounting screws.
4. If necessary, repeat STEPS 1-3 to replace the other armrest pad.
4.4 Disengaging the seat to rotate it or remove
it
The seat can be turned to one side to make getting in and out of the
scooter easier. The seat is also easier to remove from this position.
16
The seat lever A is located under the seat in the front.
Rotating the seat
1. Pull the lever upwards to disengage the seat.
2. Turn the seat to the side.
Removing the seat
1. Pull the lever upwards to disengage the seat.
2. Hold the seat firmly by the backrest and front edge and remove
it upwards.
Installing the seat
1. Lower the seat assembly onto the seat post.
2. Allow the seat to drop into the locked position.
3. Lift up on the seat assembly to ensure the seat is secure.

4.5 Adjusting the seat height

The seat height can be adjusted to 390, 410, or 430 mm.
1576371-B