Troubleshooting Guides - HotSpring Limelight Owner's Manual

TROUblESHOOTINg
should you experience any problem, do not hesitate to contact your authorized Hot Spring
rectify some more common sources of trouble yourself, if you choose to do so.
gEnEral oPEration trouBlEShooting guidE
Problem
entire spa is inoperative
Spa does not heat; jets and
light operate (Ready and Power
indicators are blinking)
Jets weak or surging
Light(s) inoperative
Power indicator blinking (entire spa
inoperative)
Ready indicator blinking
Blue Logo "Power" indicator
blinking
Green Logo "Ready" indicator
blinking
Service Information
Probable causes
• Power failure
• GFCI tripped
• Heater high-limit thermostat tripped
• Spa lock activated
• Integrated pressure switch open
• Circulation pump thermal cut-off
tripped
• Spa water level too low
• Filter(s) clogged
• Closed Air Control levers
• Spa lock activated
• Light, wiring or assembly is faulty
• Spa water level too low
• Filter(s) clogged
• Closed Air Control levers
• Temperature sensor problem
• Heater high-limit thermostat tripped
• Temperature sensor problem
Page 51
®
dealer. Here are some tips to help you to diagnose and
Solutions
• Check power source
• Reset GFCI; call for service if it will not reset
• Disconnect power for at least thirty seconds to reset heater high limit. If it
will not reset, check for clogged filter(s). If tripping continues, call for service.
• Deactivate spa lock
• check for clogged filter. Integrated pressure switch will reset when the flow
of water through the heater has been restored. call for service if the heater
trips frequently.
• Check for clogged filter or air locks in plumbing. Disconnect power to the
spa, allow circulation pump to cool. circulation pump thermal cut-off will
reset when pump has cooled and power is reapplied. call for service if
circulation pump thermal cut-off trips frequently.
• Add water
• Clean filter
• Open Air Control levers
• Deactivate spa lock
• Call for service
• Disconnect power for at least thirty seconds to reset heater high limit. If it
will not reset, check for clogged filter(s). If tripping continues, call for service.
• Disconnect power for at least thirty seconds. If blinking continues, call for
service.
• Disconnect power for at least thirty seconds to reset heater high limit. If it will not reset,
check for clogged filters. If tripping continues, call for service.
• Disconnect power for at least thirty seconds. If blinking continues, call for service.
Page 51