Installation (30"W.); Door Removal (30"W.); Connecting Gas & Electrical (30"W.) - Viking VGSO100 Installation Manual

Door Removal (30"W.)

Installation (30"W.)

NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
2
1
Open door completely. Place pin in pin hole.
Note: Two pins included.
4
Close until pins stop door.
16
1
Remove wooden brace on front of pallet.
3
Remove hinge trim screws. Take off hinge trim.
5
Lift door up and out.
Note: Do not lift door using handle.
Connecting Gas & Electrical (30"W.)
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer's
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
1
Connect gas and electrical. Before placing appliance in
operation, always check for gas leaks. This must be
performed by your dealer, a qualified licensed plumber,
or gas service company.
17
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify your appliance has been
properly grounded in accordance with
local codes or in absence of codes, with
the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.
Note: Refer to "Electrical & Gas
Requirements" section for proper
installation information.