Final Installation (36"W. Single); Final Installation (36"W. Double) - Viking VGSO100 Installation Manual

Final Installation (36"W. Single)

1
Lift oven into position.
3
Remove all knobs, push buttons, and bezels on the
right control panel.
5
Insert four wood screws, (included with the oven),
through the cabinet side flange into the cabinet.
22
2
Push oven straight into cabinet.
4
Remove lower access panel, side trim, and
control panel.
6
Replace lower access panel, side trim, and
control panel.

Final Installation (36"W. Double)

Note: Purchase necessary gas kit – IKD-VGSO.
1
Install upper oven as described on page 21, "Final
Installation" (36"W. single).
3
3
Remove access panel from oven side and
pipe plug from pipe tee.
5
Replace access panel.
23
2
Place bottom oven on a protected area near the
cabinet. Remove 2" hole knockout from oven top.
4
2
3
1
Attach male connector to pipe tee. Feed flex tubing
through 2" hole and attach to the male connector.
6
Push lower oven straight into cabinet.