Installation - Sharp FO-DC635U Service Manual

FO-DC635U

[5] Installation

1. Site selection
Take the following points into consideration when selecting a site for
this model.
ENVIRONMENT
• The machine must be installed on a level surface.
• Keep the machine away from air conditioners, heaters, direct sun-
light, and dust.
• Provide easy access to the front, back, and sides of the machine.
In particular, keep the area in front of the machine clear, or the orig-
inal document may jam as it comes out after scanning.
• The temperature should be between 50 - 86°F (10 - 30°C).
• The humidity should be between 20% and 85% (without conden-
sation).
ELECTRICITY
AC 120V, 60Hz, grounded AC (3-prong) outlet.
Caution!
• Connection to a power source other than that specified will cause
damage to the equipment and is not covered under the warranty.
• If your area experiences a high incidence of lightning or power
surges, we recommend that you install a surge protector for the
power and telephone lines. Surge protectors can be purchased at
most telephone specialty stores.
TELEPHONE JACK
A standard telephone jack must be located near the machine. This is
the telephone jack commonly used in most homes and offices.
• Plugging the fax machine into a jack which is not an RJ11C jack
may result in damage to the machine or your telephone system. If
you do not know what kind of jack you have, or need to have one
installed, contact the telephone company.
If the machine is moved from a cold to a warm place...
If the machine is moved from a cold to a warm place, it is possible that
the reading glass may fog up, preventing proper scanning of docu-
ments for transmission. To remove the fog, turn on the power and wait
approximately 2 hours before using the machine.
2. Assembly and connections
1) Connecting the power cord
Connect the female end of the power cord to the fax machine as
shown. Insert the male end into a 120 V, 60 Hz, grounded (3-prong)
AC outlet.
Important!: The fax machine requires its own dedicated power out-
let. The power outlet must not be shared with any other devices. In
particular, do not use an extension cord to connect multiple devices
to the outlet.
Note: If your area experiences a high incidence of lightning or
power surges, we recommend that you install surge protectors for
the power and telephone lines. Surge protectors can be purchased
at most telephone specialty stores.
Press the power
switch to turn on
the power.
2) Connecting the telephone line cord
Insert one end of the line cord into the jack on the back of the
machine marked TEL. LINE. Insert the other end into a standard
(RJ11C) single-line wall telephone jack.
Note: The fax machine is set for touch-tone dialing. If you are on a
pulse dial (rotary) line, you must set the fax machine for pulse dial-
ing by changing Option Setting 22.
3) Attaching the ADF exit tray
Insert the protrusion on the right side of the machine into the hole in
the right side of the ADF exit tray
slightly and insert so that the protrusion on the left side of the
machine goes into the hole on the left side of the ADF exit tray
. Pull out the tray extension
2
2
4) Attaching the received document tray
Slide the received document tray into the machine as shown. When
it stops, lift the end slightly and push in so that the tray locks into
place.
Important!: The received document tray must be attached for the
fax machine to operate properly.
1 – 7
, then bend the tray
1
.
3
1
3