Circuit Description Of Liu Pwb - Sharp FO-DC635U Service Manual

FO-DC635U

[4] Circuit description of LIU PWB

1. LIU block operation description
1.1. Block diagram
SURGE
DIODE
LINE PROTECTION
BRIDGE
HI
CIRCUIT
LO
HS
DETECTOR
EXT.TEL
DETECTOR
1.2. Circuit description
The LIU PWB is composed of the following 9 blocks.
1. Surge protection circuit
2. On-hook status detection circuit
3. Dial pulse generation circuit
4. CML relay
5. Matching transformer
6. Hybrid circuit
7. Signal selection
8. CI detection circuit
9. Power supply and bias circuits
1.3. Block description
1.3.1 Surge Protection circuit
This circuit protects the circuit from the surge voltage occurring on the
telephone line.
• The AR1 protect the circuit from the 390V or higher line surge volt-
ages.
• The AR2 and AR3 protect the circuit from the 500V or higher verti-
cal surge voltages.
• The ZD6 and ZD7 control the voltage generated on the secondary
side of matching transformer to 2V.
ACTIVE
CHOKE
CI
+5V
LIU CONTROL
TXOUT TXOUT
HI
RXIN RXIN
LO
VREF
CML0 CML0
XEXHS0 XEXHS0
XCI0 XCI0
LO
HI
HI
LO
SPEAKER
+5V
+24VA
DG
Fig. 8
1.3.2 On-hook status detection circuit
The on-hook status detection circuit detects the Status of the push
speaker key, and the status of the hook of a telephone externally con-
nected.
• External telephone hook status detection circuit (XEXHS0)
This circuit comprises the photo-coupler PC3, resistors R13 and
R12, Zener diodes ZD1 and ZD2. When an external telephone is
connected and enters the on-hook mode, the LED of photo-coupler
PC3 emits light and the light receiving element turns on. The status
signal XEXHS0 is input to the pin10 of (SUB ASIC) (IC21: Control
PWB).
XEXHS0 LOW: EXT. TEL OFF-HOOK
XEXHS0 HIGH: EXT. TEL ON-HOOK
1.3.3 Dial pulse generation circuit
The pulse dial generation circuit comprises CML.
CML ON: Make
CML OFF: Break
1.3.4 CML relay
The CML relay switches over connection to the matching transformer
T1 while the FAX is being used.
1.3.5 Matching transformer
The matching transformer performs electrical insulation from the tele-
phone line and impedance matching for transmitting the FAX signal.
1.3.6 Hybrid circuit
The hybrid circuit performs 2-wire-to-4-wire conversion using the IC of
operational amplifier, transmits the voice transmission signal to the
line, and feeds back the voice signal to the voice reception circuit as
the side tone.
5 – 16
TXA2
TXA1
MODEM
(FM336PLUS)
RIN
SPKR
CML0
XESHS0
XCI0
MONSEL
HI
BZOUTEN
LO
BZCONT
SPMUTE
VOLC
VOLB
VOLA
SUB ASIC