Yamaha RS90K Service Manual page 391

F Fuel sender terminal cover
G Fasten the speed sensor lead
only. (RS90/RS90R/RSG90/
RS90M)
Fasten the speed sensor lead
and passenger grip warmer relay
lead with the holder. (RST90/
RST90TF)
H Fasten the hose protector of the
fuel tank breather hose. (RS90/
RS90R/RSG90/RS90M)
Fasten the fuel tank breather
hose, speed sensor lead, and
passenger grip warmer relay
lead with the holder. Secure the
frame cross member and the
holder to the frame with the nut
and bolt. (RST90/RST90TF)
I Hose protector
J Face the ends of the clamp
upward.
K Install the fuel tank breather hose
onto the breather pipe until it
contacts the running board sup-
port.
L Install the passenger grip
warmer relay on one of the three
tabs. (RST90/RST90TF)
M To the speed sensor
N 60 ~ 70 mm (2.4 ~ 2.8 in)
O Route the float chamber air vent
hoses behind the battery
bracket.
P Ground leads
Q To the oil tank
R To the parking brake
S To the brake caliper
T Brake hose
U Less than 50 mm (2.0 in)
CABLE ROUTING
9-39
SPEC