Removal; Installation - Yamaha RS90K Service Manual

1
3
2
ENGINE ASSEMBLY

REMOVAL

1. Remove:
• Rear engine mounting nut
• Front engine mounting nuts
• Washers
NOTE:
Do not remove the engine mounting bolts.
2. Remove:
• Engine assembly
Removal steps:
• Screw in the engine mounting bolt spacers
(front and rear) using the engine mount spacer
wrench 1 so that there is a gap between each
engine mounting bolt spacer 2 and engine
damper 3.
Engine mount spacer wrench:
90890-01489, YS-01489
• Remove the engine mounting bolts, and then
remove the engine assembly.

INSTALLATION

NOTE:
After installing all parts, refer to "CABLE ROUT-
ING" in CHAPTER 9, to check the cable, lead and
hose routing.
1. Install:
• Engine assembly
NOTE:
Use the pivot shaft wrench to tighten the engine
mounting bolt spacers.
Installation steps:
• Install the engine mounting bolt spacers (front
and rear).
• Install the engine assembly and then, install the
rear engine mounting bolt, front engine mount-
ing bolts and washer.
5-9
ENG