Bauhn AS-PVR1000R Instruction Manual page 11

Controls and Connections (Cont.)
Antenna Requirements
• You may not need to change or replace your existing TV antenna to receive digital
reception. However, if your antenna is not in a good condition, it is recommended
that you consider replacing it to ensure uninterrupted digital television viewing.
• Viewers in areas of poor analog reception may need specialist advice about
antenna requirements for digital reception in their area.
• We recommend using quad shielded cable connecting the antenna to the TV.
Connections to a TV
There are several ways of connecting the HDD PVR to your TV and Hi-Fi System. For
High Definition viewing, your TV must support 720p, 1080i or 1080p resolution.
Your connections between the HDD PVR and TV must be either HDMI or YPbPr
(Component). Other connections will only provide Standard Definition viewing.
Before connecting your equipment, make sure all units are
switched off and unplugged from the mains power supply.
For Standard Definition Viewing:
Connect the HDD PVR receiver via CVBS (composite) and Audio
1. Connect the loop cable to LOOP IN and to LOOP OUT.
2. Connect the antenna to the ANT IN socket of the unit.
3. Connect the unit via CVBS (AV) & Audio L/R, as illustrated below.
Antenna
LOOP IN ANTI N
ANTO UT LOOP OUT
TUNER-S TUNER-M
After Sales Support
Telephone:
Email: info@tempoaustralia.com.au
WARNING:
CVBS L
SPDIF USB HDM I YP
1300 886 649
TV Interface
VIDEO INPUT AUDIO INPUT
LR
R
bP r
100-240V~
50/60Hz
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPE N
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER. NO USER, SERVICEABLE PARTS INSIDE .
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL .
11