AT&T 1856 Quick Start Manual page 5

Speakerphone/answering system with caller id/call waiting

Hide thumbs Also See for 1856:

Installation options

Rotate the bracket to the wall installation position. Plug one end of the

telephone line cord into the jack of the telephone base. Place the telephone

line cord through one channel on the bracket. Bundle the telephone line cord

and place it inside the bracket. Place the other end of the telephone line cord

through the other channel on the bracket.

Insert the tabs of the bracket into slots

press the other bracket tabs into slots

5. Plug the power adapter into an electrical outlet not controlled by a wall switch. Plug

the other end of the telephone line cord into a telephone wall jack. To mount the

telephone on the wall, position the mounting holes

outlet mounting studs. Press and slide the bracket down firmly so the telephone is

held securely on the telephone outlet mounting studs.

Place the bundled telephone

line cord inside the bracket.

Tabletop installation

To return the bracket from the wall installation to tabletop position, follow the

directions below.

. Remove the telephone base from the wall. Unplug the cords from the wall

jacks. Remove the bracket from the telephone base. Remove the telephone line

cord from the channels. Untie the bundled telephone line cord.

and

on the telephone base, then

and

as shown below.

and

over the telephone

Table of Contents