Camera Recording - Panasonic Digital Palmcorder PalmSight PV-DV200-K Operating Instructions Manual

Camera Recording

Simple Recording
POWER
Lamp
Vision
Adjustment
Control
RECORD/
PAUSE
Button
WARNING:
• Do not leave the Palmcorder with the
EVF aimed directly at the sun as this
may cause damage to the internal parts
of the EVF.
• Do not lift, or carry, the Palmcorder by
the EVF or the LCD Monitor.
30
200_400-K.30-39.p65
Before you begin...
• Connect the Palmcorder to a power source
(pages 12, 13).
• Insert a cassette with record tab closed
(page 15).
Remove the lens cap and clip it to the
hook.
TALLY LED
Lights during recording.
1
Set POWER to CAMERA.
POWER
• The POWER lamp lights red.
Switch
• Be sure POWER
2
With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight
(page 9).
3
Press RECORD/PAUSE to start
recording.
The Tally LED will be on.
To turn the Tally LED off, see TALLY
LED on page 23.
Press RECORD/PAUSE again to
pause recording.
• To reduce microphone wind noise,
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the picture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
To conserve power
After 5 minutes, the Record/Pause mode will
automatically change to Standby mode.
To resume recording, set POWER to OFF
and then ON again.
30
is fully turned to
CAMERA position.
Record/Pause mode.
set the WIND-CUT (PV-DV400-K only)
to ON (see WIND-CUT on page 23).
00/06/14, 13:11
EVF
PAUSE