Is-Relay Card - Liebert NXC 30kVA User Manual

74 Chapter 8 Options
The IS-WEBL card is a network management card. It can make the UPS made by Emerson Network Power Co., Ltd
real network equipment. It can also be connected to the IRM series sensor to provide environment monitoring function.
When the intelligent equipment generates an alarm, the IS-WEBL card can notify the user by recording the log,
sending trap information, and sending a mail.
Preparation
1. Prepare the installation tools, including a cross head screwdriver.
2. Check that all installation materials are present and complete, including an IS-WEBL card.
Procedures
No need to shut down the UPS during IS-WEBL card installation, because the IS-WEBL card is hot pluggable.
Some electron components in IS-WEBL card are sensitive to static, therefore, do not touch the electron components or circuit in
IS-WEBL card by hand or other conductive materials, so as to protect the IS-WEBL card against static shock. When removing or
installing the IS-WEBL card, hold the card side edge to operate it.
The IS-WEBL card should be installed in the Intellislot port (see Figure 3-5) in the UPS. See Table 3-9 for installation
positions of optional cards.
Method for installation:
1. Remove the cover of Intellislot port. Note to reserve the removed screws and take care of the cover for future use.
2. Insert the IS-WEBL card (along two sides of the Intellislot port) into the port position recommended in Table 3-9, and
then fasten the screws.
For more information of the IS-WEBL card, refer to the Liebert IntelliSlot Web Card Quick Start Guide in accessory.
Refer to 3.2.11 Signal Cable Connection Steps for the cabling and routing of the signal cables.

8.2.7 IS-Relay Card

Figure 8-16 shows the appearance of the IS-Relay card.
Figure 8-15 IS-WEBL card
Liebert NXC 30kVA And 40kVA UPS User Manual
Note
Warning