Oil Injection Pump Air Bleeding - Yamaha WaveRunner GP800R Service Manual

FUEL
1
2
OIL PUMP
1
2. Adjust:
Oil pump cable
Adjustment steps:
Loosen the locknut 1 and the adjust-
ing nut 2.
Fully close the carburetor throttle
valves.
Adjust the oil pump cable so that the
mark a on the oil pump lever is
aligned with the mark b on the oil
pump body.
Tighten the adjusting nut and locknut.

Oil injection pump air bleeding

1. Bleed:
Air
Air bleeding steps:
Place rags around the air bleed screw
1 to catch any oil that might spill.
Fill the oil tank with the recommended
oil.
NOTE:
If the oil pump is replaced or the oil suc-
tion hose is removed, bleed air from the
oil suction hose by removing it from the
oil pump.
After bleeding the air, reconnect the
hose with a locking tie.
Recommended engine oil:
YAMALUBE 2-W or an
equivalent TC-W3 certified
outboard oil
Loosen the air bleed screw 1 two full
turns and make sure that both the oil
and air bubbles flow out.
When there are no air bubbles left,
tighten the air bleed screw.
Wipe up any spilt oil.
4-31
E