Table of Contents
Advertisement
INSP
ADJ
POWER UNIT/ELECTRICAL
3. Measure:
Spark plug gap a
Out of specification → Regap.
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
4. Tighten:
Spark plug
Spark plug:
25 N • m (2.5 kgf • m, 18 ft • lb)
NOTE:
Before installing the spark plug, clean the
gasket surface and spark plug surface.
Also, it is suggested to apply a thin film of
anti-seize compound to the spark plug
threads to prevent thread seizure.
If a torque wrench is not available, a good
estimate of the correct tightening torque
for a new spark plug is to finger tighten a
the spark plug and then tighten it another
1/4 to 1/2 of a turn b.
ELECTRICAL
Battery inspection
WARNING
Battery electrolyte is dangerous; it contains
sulfuric acid which is poisonous and highly
caustic.
Always follow these preventive measures:
Avoid bodily contact with electrolyte as it
can cause severe burns or permanent eye
injury.
Wear protective eye gear when handling
or working near batteries.
Antidote (EXTERNAL):
SKIN - Wash with water.
EYES - Flush with water for 15 minutes
and get immediate medical attention.
3-10
E
Advertisement
Chapters
Table of Contents
