Table of Contents
Advertisement
accessory equipment, the radio will not
transmit.
Is the gain setting correct for the microphone
input or ACC 1 jack as appropriate?
Is the POWER control turned all the way
down? Press PWR and check.
If no transmit in digital modes, are you sure
a PTT signal is being sent from your TNC or
computer to the appropriate jack on the
OMNI-VII?
Is OVER TEMP displayed on the radio
screen? At a final amplifier temperature of
70 degrees C or higher, the radio will stop
transmitting for a minimum of one minute.
See ON-SCREEN STATUS MESSAGING
elsewhere in this manual.
Problem: No operation in VOX
Is "VOX" highlighted at the bottom of the
screen? If not, VOX is turned off.
Check the OMNI-VII menu to see if the
items for VOX are active and set properly. If
any of the three settings is at zero, VOX will
not operate.
The mic element in other (non-Ten-Tec)
microphones must be active (open) when
used in VOX mode with OMNI-VII. This
generally means locking the PTT on the
microphone after putting the radio into VOX
mode – but every mic is different. Consult
the operation manual of your microphone.
If the above do not solve your problem,
please consult with our service department
(865) 428-0364 or service@tentec.com
588 manual
Second release – August 2007
36
Part #74409
Printed in USA
Advertisement
Table of Contents
