Visonic KP-140 PG2 User Manual

KP-140 PG2/KP-141 PG2
Portable Remote Wireless 2-Way Keypad
1. INTRODUCTION
KP-140 PG2 and KP-141 PG2 are 2-way PowerG wireless keypads
for the PowerMaster family control panels. The KP-141 PG2 is the
same as the KP-140 PG2 but also includes a built-in proximity RFID
tag reader. Both keypads enable most common everyday user
functions:
• Arm and Disarm the alarm system.
• Initiate Emergency, Fire and Panic alarms.
• Control X-10 devices and PGM output.
• Perform one of the AUX (auxiliary) predefined functions.
• Review system Status.
When authorization is required, for example, to arm or disarm the
system, the user can enter his PIN Code via the built-in numerical
keypad or alternatively present a valid proximity tag to the built-in tag
reader (only with KP-141PG2) located at "N" in Figure 1.
In addition, the KP-140 PG2/KP-141 PG2 keypad supports panels
featuring Partitions. Partitioning allows you to have up to three
controllable areas; each partition can be armed and disarmed
independently regardless of the status of the other two partitions by
the same or different users (see buttons marked "E" in Figure 1).
The keypads can be wall mounted using the supplied bracket or be
used as portable units. For compliance with various international
standards, the keypads are equipped with two tamper switches that
can be configured to detect when the cover of the battery
compartment is removed or when the unit is removed from its
mounting bracket.
Other features of the KP-140 PG2/KP-141 PG2 keypad include:
• Status, alarm memory, trouble and Ready / Not-Ready indications.
• Automatic reporting of low battery voltage.
• Keypad back lighting.
• Exit/entry beeps
• Tag reader can also be used to enroll proximity tags into the panel.
• Long-life 4-5 years battery life expectancy (for typical use), 3 VDC
lithium battery.
2. INSTALLATION
2.1 Mounting and Battery Replacement
1
2
1. Drill 2 holes in mounting surface, insert wall anchors and fasten the
bracket with 2 screws.
2. Place the "Visual Indications" sticker within the frame.
3. Slide the keypad into the bracket.
A. Magnet (activates back tamper when bracket is removed from the
wall).
Figure 2 - Mounting
D-303015
3
A
B
A
C
E
F
H
I J
K
A. ARM HOME
B. ARM AWAY
C. DISARM
D. X-10 / PGM
E. PARTITION SELECTION
F. ARM INSTANT
G. STATUS / ESCAPE
Figure 1 - External View
1. Slide out the cover.
2. Replace the battery (verify proper polarity) and close the cover.
A. Battery compartment tamper switch
Figure 3 - Battery Replacement
User's Guide
L
D
N
G
H. AUX / ENROLLMENT
I. EMERGENCY ALARM
ALARM
J. FIRE
ALARM
K. PANIC
L. BUZZER INDICATOR
M. LED INDICATOR
N. TAG READER
A
1
2
M
1