To Set Other Preference Items; Digital Audio Output - JVC XV-D701BK Instructions Manual

Setting and adjustment
54

To set other preference items

PREFERENCE 2 can be set as follows:

DIGITAL AUDIO OUTPUT

To connect the unit's digital output to an
external amplifier or receiver equipped
with a digital input, this item must be set
correctly.
• PCM ONLY:
When you connect the DIGITAL OUT jack
of the unit and the linear PCM digital
input of a piece of audio equipment.
• STREAM/PCM:
When you connect to the digital input of an amplifier with built-in DTS Dolby
Digital, and MPEG Audio decoder.
• DOLBY DIGITAL/PCM:
When you connect to the digital input of a Dolby Digital decoder, or an amplifier
with built-in Dolby Digital decoder
The following chart shows the relationship between types of playback discs and
output signals.
Playback discs
STREAM/PCM
48-kHz, 16-bit linear
DVD with 48-kHz,
PCM
16-bit linear PCM
48-kHz, 20-bit linear
DVD with 48-kHz,
PCM
20/24-bit linear PCM
No output
DVD with 96-kHz,
linear PCM
DTS bitstream
DVD with DTS
Dolby Digital
DVD with Dolby
bitstream
Digital
MPEG bitstream
DVD with MPEG
audio
44.1-kHz, 16-bit linear
Video CD
PCM
44.1-kHz, 16-bit linear
Audio CD
PCM
DTS bitstream
Audio CD with DTS
NOTES
¶
The unit does not provide the DTS decoding function.
¶
When playing back an audio CD with DTS, only use a DTS decoder (or an amplifier
with a built-in DTS decoder). Playing back such a disc outputs an incorrect signal
from the analog output jacks, which may cause damage of speakers.
If you connect the analog outputs and digital outputs simultaneously, be
sure to select the source of the amplifier correctly, or set the level control of
the amplifier connected to the analog outputs to minimum.
PREFERENCE1 PREFERENCE2 SPK.SETTING
DIGITAL AUDIO OUTPUT STREAM/PCM
DOWN MIX Lt/Rt
COMPRESSION ON
MODE1
SCREEN SAVER
AUTO STANDBY OFF
PRESS KEY
Output
DOLBY DIGITAL/PCM
PCM ONLY
No output
48-kHz, 16-bit
linear PCM
48-kHz, 16-bit linear
PCM