To Set Other Preference Items; Digital Audio Output - JVC XV-D701BKB Instructions Manual

Setting and adjustment
56

To set other preference items

The PREFERENCE 2 can be set as follows:

DIGITAL AUDIO OUTPUT

To connect the unit's digital output to an
external amplifier or receiver equipped
with a digital input, this item must be set
correctly.
• PCM ONLY:
When you connect the DIGITAL OUT
jack of the unit and the linear PCM
digital input of an audio equipment.
• STREAM/PCM:
When you connect to the Dolby digital input of an amplifier with built-in DTS
and Dolby Digital decoder.
• DOLBY DIGITAL/PCM:
When you connect to the Dolby digital input of a Dolby Digital decoder, an
amplifier with built-in Dolby Digital decoder
The following chart shows the relationship between types of playback discs and
output signals.
Playback discs
STREAM/PCM
48-kHz, 16-bit linear
DVD with 48-kHz,
PCM
16-bit linear PCM
48-kHz, 20-bit linear
DVD with 48-kHz,
PCM
20/24-bit linear PCM
No output
DVD with 96-kHz,
linear PCM
DTS bitstream
DVD with DTS
Dolby Digital
DVD with Dolby
bitstream
Digital
MPEG bitstream
DVD with MPEG
audio
44.1-kHz, 16-bit linear
Video CD
PCM
44.1-kHz, 16-bit linear
Audio CD
PCM
DTS bitstream
Audio CD with DTS
NOTES
¶
When you play a CD disc with DTS, unnecessary audio signal output from
the AUDIO OUT (analog) jack. Adjust the volume level of an amplifer
connected to the AUDIO OUT jack of the unit to minimum.
¶
When you do not connect the unit to the DTS decoder, a CD disc with DTS
cannot be played back. Do not play a CD disc with DTS when the unit is
connected to the DIGITAL jack other than it of the DTS decoder. If you do
so, loud noise may be played back from speakers, and it cause of the
breakdown of your speakers.
PREFERENCE1 PREFERENCE2 SPK.SETTING
DIGITAL AUDIO OUTPUT STREAM/PCM
DOWN MIX Lt/Rt
ON
COMPRESSION
SCREEN SAVER MODE1
DVD1
AV COMPULINK MODE
AUTO STANDBY OFF
PRESS KEY
Output
DOLBY DIGITAL/PCM PCM ONLY
No output No output
48-kHz, 16-bit
linear PCM
48-kHz, 16-bit linear
PCM