Getting started
To connect to an amplifier/receiver equipped with 5.1-channel inputs
The Dolby Digital decoder and MPEG Multichannel decoder are built in the unit, so you can enjoy the Dolby digital
and MPEG Multichannel surround sound without the need of an external decoder.
Connect the unit's 5.1-channel outputs to the 5.1-channel inputs of an amplifier or receiver using the supplied audio
cables.
VIDEO OUT
VIDEO S-VIDEO
FRONT
LEFT
RIGHT
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on
units.
• An Audio/video cable is recommended for connection to the FRONT terminal (Yellow jack (for Video Signal) is not
used in this connection).
NOTE
¶
When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display
to "OFF" and select "5.1 CHANNEL" or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is
selected, you can control the audio output balance of the speakers (see pages 55 and 57).
14
The unit
AV OUT
AV
Y/C
COMP.
REAR
CENTER
PCM/STREAM
OPTICAL
COAXIAL
SUBWOOFER
ANALOG
DIGITAL
AUDIO OUT
Audio cable (supplied)
Audio/video cable (supplied)
Audio cable (supplied)
Amplifier or receiver
CENTER
White
SUBWOOFER
Red
FRONT
White
Yellow
Red
REAR
White
Red
AUDIO IN
LEFT
RIGHT
LEFT
RIGHT