Entering Diagnostics - Electrolux Affinity Service And Diagnostics

Entering Diagnostics

1. Turn the Program Knob to Spin Only. This is the start
position for the diagnostic test.
2. Press Start/Pause to start the cycle.
3. Press Cancel to stop the cycle and turn off the LEDs.
4. Press any button on the console, other than the Cancel
Button, to turn on the LEDs.
5. Within 5 seconds, press and hold the Options and
Start/Pause buttons simultaneously until all the LEDs start
sequentially flashing, then release the buttons. The unit is
now in the diagnostic test mode.