Electrolux Affinity Service And Diagnostics page 60

Test (1)
Test (2)
Tests
1. Is the incoming water flow normal?
2. Is the water supply turned on?
3. Is the water pressure sufficient?
4. Does water continue to fill the
washer?
5. Remove power from the unit. Did the
water fill stop?
6. Check the pressure sensor.
7. Replace the control board.
1. Is the washer leaking water?
2. Is there an air leak in the air bell
system?
3. Check the pressure sensor.
4. Replace the main control board.
Yes. Go to step (4).
No. Go to step (2).
No. Turn on water supply.
Yes. Go to step (3)
No. Have the customer correct the pressure
problem.
Yes. Check for kinked or blocked water
supply hoses. Correct if kink or blockage is
found. If there is no kink or blockage,
replace water valve assembly.
Yes. Go to step (5).
No. Go to step (6).
Yes. Go to step (6).
No. Replace water valve assembly.
Pressure sensor checks good. Go to step (7).
Pressure sensor checks bad. Replace
pressure sensor.
Yes. Correct water leak.
No. Go to step (2).
Yes. Correct air leak.
No. Go to step (3).
Defective. Replace pressure sensor.
Pressure sensor checks good. Go to step (4)