Electrolux Affinity Service And Diagnostics page 65

Test 11
Test 12
Test 13
Test 14
Tests
1. Check the wiring between the main
control board and the motor control
board.
1. Contact the power supply company to
check incoming power frequency.
1. Check the heating element resistance.
Element resistance should be
approximately 30 ohms.
1. Check the resistance of the tub NTC. Is
the NTC resistance approximately 4.8K
ohms.
Wiring is defective. Repair or replace wiring.
Wiring checks good. Replace the main
control first. If this does not repair the error,
replace the motor control board.
If the frequency is correct, replace main
control board.
If reading is correct, replace the main control
board.
No. Replace the heating element.
Yes. Check the wiring.