Function Check - Truma BOA Operating Instructions Manual

Conection with
specific vehicle or
manufacturer control
panels
Connect control panel cable,
230 - 240 V cable and heating
element cable as shown in
the drawing.
Cables must be in accordance
with the technical rules and
regulations of the country in
which the vehicle is to be regi-
stered, for the first time (e.g.
in Germany VDE 0100, section
721).
supply line
heating
3 x 1,5 mm 2
element
splitting box
L N PE N' L'
control panel
9

Function check

After installation, check gas
supply line for leaks in accor-
dance with the pressure drop
method. Following this,
check the function of the ap-
pliance as specified in the
operating instructions, check
the function of the draining of
the water contents, in particu-
lar. There shall be no claims
under guarantee for dama-
ge caused by frost!
Never operate the water
heater without water con-
tents. It is, however, possible
to briefly check the electrical
function without water con-
tents. Always observe the
operating instructions prior to
operation!
The operating instructions
and completed guarantee
card are to be given to the
owner of the vehicle.
10
Warning information
The installer or vehicle owner
must apply the yellow sticker
with the warning information,
which is enclosed with the
appliance, to a place in the
vehicle where it is clearly visi-
ble to all users (e.g. on the
wardrobe door)! Ask Truma to
send you stickers, if neces-
sary.
7