3-Pin To 5-Pin Conversion Chart; Setting Up A Dmx Daisy Chain - Chauvet Gobo Zoom LED 2.0 User Manual

3-Pin to 5-Pin Conversion Chart

Setting up a DMX Daisy Chain

Page 12 of 15
If you use a controller with a 5-pin DMX output connector, you will need to use a
5-pin to 3-pin adapter. The chart below details a proper cable conversion:
3-P 5-P
IN TO
3-Pin Female (Output)
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Not used
Not used
1. Connect the (male) 3-pin connector side
of the DMX cable to the output (female)
3-pin connector of the controller.
2. Connect the end of the cable coming
from the controller which will have a
(female) 3-pin connector to the input
connector of the next product consisting
of a (male) 3-pin connector.
Then, proceed to connect from the
3.
output as stated above to the input of
the following product and so on.
C C
IN ONVERSION HART
5-Pin Male (Input)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4
Pin 5
Continue the link
Universal DMX Controller
This drawing
provides a general
illustration of the
DMX input/output
panel of a lighting
product.
Gobo Zoom LED 2.0 (Rev. 02)