Radio Operation - Sirius XM RAdio XSG2NA-X2S Owner's Manual

Radio mode can be selected from the Main Menu by pressing the Radio icon on the LCD display. The Radio mode can be left at any time by tapping the Radio icon at the top
left of the Radio screen. The radio interface contains several buttons that all have their specific purpose. Below is an explanation of each button and its functionality.
Note: Some radios show a basic display. To change to full display as below, go to settings: radio: full.
1
8
9
6
2
7
Tap to allow the selection between the FM and AM bands. There are 3 FM and
1
2 AM ranges available, all with 6 available presets.
Tap to allow fine tuning or manual searching for radio stations.
2
Tap to start automatic searching for the next radio station.
3
A/S means Auto Store and will store received stations in the memory. Six stations
4
will be stored per radio band.
P/S means Program Scan and will go through all the frequencies stored in the
5
memory and pauses for 10 seconds. To stay at a specific station, press the Seek
button.
DX is the default mode. When LO is selected, the sensitivity of the radio receiver is
6
reduced so that only the strongest signals are found when searching. Tap to switch
between DX and LO.
XiteSolutions North America Inc.
10
11
4
5
3

4. Radio Operation

These six buttons can be used to switch to a radio station in the memory by tapping
These six buttons can be used to switch to a radio station in the memory by tapping
7
it once or storing a station by holding it for 2 seconds.
8
AF means Alternative Frequencies. When this function is activated, the radio will
search for other frequencies on which the same station is present to offer the best
reception. The AF button will blink when activated.
PTY means Program Type. Some radio stations broadcast their program type.
9
When the PTY button is pressed, use the
TUNE and SEEK buttons to select the program type to search and listen to
POP M ROCK M EASY M
JAZZ COUNTRY NATION M
AFFAIRS INFO SPORT
SCIENCE VARIED WEATHER
RELIGION PHONE IN TRAVEL
TA means Traffic Announcement and will interrupt any audio source when a traffic
10
announcement message is relayed from a radio station supporting this functionality.
When the volume is set lower then 10, a TA message will automatically raise the
volume to 10.
REG means Regional and this functionality will support the AF functionality by
11
searching for local broadcasts to improve reception of local radio stations.
Note: The reception and audio quality is highly dependent on the strength of the incoming
signal from the radio broadcasting. When experiencing difficulties with getting a good
reception, moving the vehicle to a different location can improve the audio reception. When
problems persist, please contact your dealer for a solution
LIGHT M CLASSICS OTHER M
OLDIES FOLK M NEWS
EDUCATE DRAMA CULTURE
FINANCE CHILDREN SOCIAL
LEISURE DOCUMENT
.
14