Setup Menu Configuration - JVC D-ILA LD-HD2KBU Instructions Manual

Adjustments and Settings Using Menus (continued)

Setup Menu Configuration

.................................................................................................
SET: NTSC SCANRATE
(Output scan rate setting for NTSC signals)
Sets the output scan rate of NTSC signals. Set to
1920 1080 .
Setting Values:
1280 720, 1024 768, 1280
1440 960, 1280 1024, DILA, DILA3,
1920 1080, 1400 788, 1920
Default Value: 1280 720
● Press the [STORE] button twice to confirm the setting and
store it as a profile. Please refer to 19 and 26 for details on
profile setting.
.................................................................................................
SET: PAL SCANRATE
(Output scan rate setting for PAL signals)
Sets the output scan rate of PAL signals. Set to
1920 1080/50Hz .
Setting Values:
1280 720/50Hz, 1024
100Hz, 1920 1080/50Hz, 720
576/100Hz
Default Value: 1280 720/50Hz
● Press the [STORE] button twice to confirm the setting and
store it as a profile. Please refer to 19 and 26 for details on
profile setting.
.................................................................................................
SET: ACTIVE OUTPUT
(Output signal setting)
Sets whether to output analog signals (BNC, D-sub) or
digital signals (DVI) to the output terminal of this unit.
Setting Values:
ANALOG RGB+DVI, ANALOG YPrPb, DVI, ANALOG
RGB
Default Value: ANALOG RGB+DVI
● Select ANALOG RGB+DVI to output both digital and
analog signals. However, output of YPrPb signals is not
possible.
● Each of the output format can be stored as a separate
profile. (A Pages 19, 26)
● There will be no output to the analog terminal when HDCP
signals are input to the DVI input terminal of this unit. In
this case, an ENCRYPTED SOURCE ANALOG OUT
DISABLE message will appear on the LCD.
22
768, 1366 768,
540, 800 600
768/75Hz, 1024 768/
576/50Hz, 720
.................................................................................................
SET: SCREEN SHAPE
(Screen shape setting for projector)
Sets the screen shape of the projector that is connected
to this unit.
Setting Values: WIDESCREEN, WIDE 4:3, 4:3
Default Value: WIDESCREEN
oWIDESCREEN
Choose this when projecting 16:9 or 2.35:1 images
from the projector onto a wide screen.
oWIDE 4:3
Choose this when projecting a 4:3 image from the
projector onto a wide screen. (Not available on units
scanning at rates below 720p.)
o4:3
Select this when using a 4:3 screen.
.................................................................................................
SET: ANALOG BLACK LVL
(Level setting for black analog signals)
Sets the black signal level of the YPrPb component video
signal.
Setting Values: 0 IRE, 7.5 IRE
Default Value: 7.5 IRE
.................................................................................................
SET: COMP SYNC ON H
(Composite sync signal setting)
Sets the horizontal/vertical sync signals when connected
via the analog RGB output (4-wire connection). When this
is set to ON , composite sync signals will be output from
the [H SYNC] terminal.
Setting Values: OFF, ON
Default Value: OFF
● This processor is used via a DVI connection to the
projector, and therefore this setting is not required.
● Setting is enabled when you select ANALOG RGB+DVI
or ANALOG RGB in the SET: ACTIVE OUTPUT
setting.