Table of Contents
Advertisement
2 Installation
2.4
Mounting the Seismic Brackets
TIP: The seismic brackets can be removed if they are not required by local code or you
are not in an earthquake zone. Also see Section 2.5, "Locking the Wheels." If the brack-
ets are used to secure the unit to a concrete pad, go directly to
DANGER: Removing the side panels exposes dangerous voltages. Use extreme
caution. Also see Section 2.3, "Connecting the Internal Batteries."
Tools and Materials Required:
• Phillips screwdriver.
/
3
inch hex wrench for removing the seismic bracket bolts.
•
8
• If used, 0.5 inch (13 mm) or 0.75 inch (19 mm) Hilti anchor bolts.
Procedure:
1
2
Remove the two hex bolts from each seis-
mic bracket. Remove and save the brack-
ets. Screw the bolts back into the unit to
prevent loss.
3
Carefully replace the side panels re-
moved in
1
.
4
Once the unit has arrived at its installation site, reinstall the small lower-front panel by
pressing it into place until it snaps securely into position.
Remove the two
Phillips screws
from the upper
channel of each
side panel.
18
Tilt the panel downward and pull the
lower panel tabs from the unit's frame.
5
.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
