Table of Contents
Advertisement
BIOS Utilities
Installed O/S (Advanced Menu)
This setting tells the computer what kind of operating system you're using. Make
sure you choose the correct setting for your O/S in order to prevent system problems.
Note: If you select the Vista O/S then the SATA Mode Selection menu will become
available. If you are installing the Windows XP O/S make sure you have set the ap-
propriate operating system here in order to prevent system problems.
5
SATA Mode Selection (Advanced Menu)
This menu is only available if you select the Vista O/S as your operating system.
You can configure SATA (Serial ATA) control to operate in either IDE (native/
compatible) or AHCI (Advanced Host Controller Interface) modes from this menu.
The SATA mode should be set to AHCI mode for this system (unless you are sure
your hard disk can only operate in IDE mode). If you are unsure of the mode your
hard disk supports contact your service center.
DFOROM (Robson) Support (Advanced Menu > SATA Mode Selection [AHCI]
This item will only be available if you have selected AHCI in SATA Mode Selec-
tion. The option should be enabled only if you have included an optional Intel Tur-
bo Memory Module in your purchase configuration. You should then install the
driver as per the instructions in
"Intel Turbo Memory Module" on page 7 -
34.
Advanced Menu 5 - 9
Advertisement
Table of Contents
