Chevrolet Captiva OM C140 Manuals page 124

122 Instruments and controls
1. If you press the MODE and SET
button simultaneously for more
than 2 seconds, the compass
display flashes.
2. Turn the vehicle around 1
complete circle within 90 seconds
slowly, then the calibration will be
accomplished.
3. When the calibration is finished,
the compass display does not
flash anymore. You can turn
around to any direction, left or
right.
If enough space is not available
to turn around 1 circle, turn the
vehicle around as shown in the
below figure.
Release conditions for the
compass calibration
 Press the SET button twice
continuously.
 When the vehicle is not turned
within 90 seconds after
calibration mode started.
L7D2102A
Note
The direction will be displayed
while driving.
If the compass display continues to
flash, turn around again slowly
until it goes off.
Note
In the compass calibration mode,
press the SET button to move to
deflection calibration mode. At that
time, press Q or R button to adjust
deflection calibration value.
Caution
If there are mobile telephones or
magnetic bodies around the DIC,
the compass may not be operated
properly.