All-Wheel-Drive Light; Descent Control System Light - Chevrolet Captiva OM C140 Manuals

110 Instruments and controls
Antilock brake system
(ABS) warning light
! illuminates.
Illuminates for a few seconds after
the ignition is switched on. The
system is ready for operation when
the control indicator goes out.
If the control indicator does not go
out after a few seconds, or if it
illuminates while driving, there is a
fault in the ABS. The brake system
remains operational but without ABS
regulation.
See Antilock brake system (ABS) on
page 264.

All-wheel-drive light

C illuminates when the ignition is
ON and goes out after about a
few seconds.
This light blinks when AWD
system is temporarily disabled and
illuminates to indicate that there is
a malfunction in the AWD system.
If AWD system warning light
comes on, you should consult a
repairer to repair the problem as
soon as possible.
See All-wheel drive on page 262.
Descent control system
light
5 illuminates.
Active and not ready/warning
light
The green DCS light is DCS active
indicator and the amber DCS light
is DCS not ready & warning light.
DCS active indicator illuminates(as
green colour) when DCS is ready
for use and blinks(as green colour)
while DCS is operating by
pressing the DCS button lo cated
on the centre of the instrument
panel.
DCS not ready & warning light works
as the following:
 Blinks (as amber colour) to
indicate that DCS is not ready for
condition to operate due to the
high temperature (about

350~400 C) of friction
material(front pad) through
severe or repeated braking.
This light will disappear when the
temperature of friction material
(front pad) is lower than 350

C.