Miele CVA 5065 Operating And Installation Instructions page 69

. . . the slide control for the grinder
setting will not move.
^ Close the machine door and
dispense a cup of espresso coffee.
The grinder setting slide control will
now move.
. . . the message "Fault - 1" to
"Fault - 4" or "Fault - 80" to
"Fault - 83" appears in the display.
^ Switch off the machine using the
On/Off sensor, and wait for one hour
before switching it on again.
If the Fault message appears in the
display again, contact Miele.
. . . the message "Fault - 28" appears
in the display.
Enough ground coffee for one portion,
i.e. a level coffeespoonful of ground
coffee, passes through the ground
coffee chute. If there is too much
ground coffee, the machine is unable to
process it so that it can be emptied into
the waste container, and a fault
message appears in the display.
Switch the machine off and then on
again after a short while.
. . . the message "Fault -73" appears
in the display.
The brew unit cannot be positioned
correctly.
^ Take the brew unit out of the machine
and clean it thoroughly (see
"Cleaning and care - Brew unit").
Problem solving guide
^ Push the coffee ejector of the brew
unit into the correct position.
^ Set the brew unit to one side and
replace the waste container and the
water container in the machine.
^ Close the door.
The brew unit motor will now move
into the correct position.
^ When "Fit the brew unit" appears in
the display, open the door and
replace all the parts in the machine.
^ Close the door.
If the fault message continues to
appear in the display, please call Miele,
quoting the fault code.
. . . the message "Fault - 74" or
"Fault - 77" appears in the display?
^ Switch the machine off and then on
again after a short while.
If the Fault message appears in the
display again, contact Miele.
69