Miele CVA 5065 Operating And Installation Instructions page 50

Cleaning and care
^ Take the cover off together with the
milk pipework. Clean the whole
component in the dishwasher without
dismantling it.
If there is still residual milk in the
pipework after this, use the cleaning
brush supplied to remove it. To do so,
dismantle the cover and the milk
pipework as follows:
Do not take the milk pipework out of
its holder. This could cause the
pipes to leak.
^ Press down on the small recess in
the spout's holder (a) and pull the
holder forwards and out (b). Loosen
the milk pipework from its guides.
^ Take hold of the second holder by
pin (c) and pull it upwards and off.
50
The hoses can now be cleaned with a
brush under running water.
^ Push the brush into both milk pipes
from below. Move the brush in and
out of the pipes as far as it will go
until there are no milk residues left in
them.
Re-assemble the milk pipework as
follows:
^ Fit the holder with the plug into the
cover as shown. Make sure that the
holder fits correctly on the cover.